In this project, three (3) alternative design solutions were considered for the camp-bed. The authors utilize the local raw materials (with cost consideration) for the comments. The merits and demerits of each of the alternative with respect to the considered grip were also discussed and the solutions of the alternatives that best satisfied the limitations were selection, design and cost analysis, production process and operations maintenance and problem encountered during the design were also included.
TABLE OF CONTENTS
Title i
Letter of Transmission ii
Signature Page iii
Approval Page iv
Release Page v
Dedication vi
Acknowledgement vii
Abstract viii
Table of Content ix
CHAPTER ONE
1.1 INTRODUCTION 1
1.2 Limitation of Existing Camp-Bed 1
1.3 Design Specification of the Camp-Bed 2
CHAPTER TWO
2.0 LITERATURE REVIEW 3
2.1 Component Parts of the Camp-Bed 4
2.2 The Half Inches Square Pipe 4
2.3 The Catcher 5
2.4 The Cover 5
2.5 The Angle Iron 5
CHAPTER THREE
1.0 Design Solution 6
3.1 Comparison of Alternative and Choice 7
3.2 Alternative A 7
3.3 Thin Plank (Wood) and Foam Matters with ND Head Adjustment 7
3.4 Alternative B 8
3.5 Iron to Iron Camp-Bed 8
3.6 Alternative C 8
3.7 Matters (Form Alone) with Head Adjustment 8
CHAPTER FOUR
4.0 Material Selection 10
4.1 Mild Steel 10
4.2 Codes and Standards 11
4.3 Designs Selection and Analysis 12
4.4 Analysis of Parts of the Chosen Alternative 12
4.5 Analysis of How Design Fired with Factors 13
CHAPTER FIVE
Description of Camp Bed 15
CHAPTER SIX
Construction Procedure 16
CHAPTER SEVEN
7.0 Testing and Costing 19
7.1 Testing of the Prototype 19
7.2 Free Body Diagram Driving Testing 19
7.3 Costing of the Prototype 20
7.4 Machine Cost Analysis 21
CHAPTER EIGHT
Evaluation and Presentation 22
References
INTRODUCTION
Camp-bed is used universally for relaxation, emergency cases such as war, and several other purposes. The acknowledgement of these resources eventually reads to the fabrication of the camp-bed. All existing camp beds have almost the same dimension but differ in design. Some use rope and ailment while the modern design makes use of mood and spring.
The design and workshop technology, Engineering drawing, work experience gained after year one of study of this programme.