CONSTRUCTION OF A SCREW CONVEYOR WITH A SINGLE PHASE ELECTRIC MOTOR


  • Department: Mechanical Engineering
  • Project ID: MCE0333
  • Access Fee: ₦5,000
  • Pages: 46 Pages
  • Reference: YES
  • Format: Microsoft Word
  • Views: 439
Get this Project Materials
ABSTRACT

In the society at large Technology is fast replacing the crude method of carrying out work and has been making room for employment. Besides, it has also caught the attention of the youths who will prefer to work in a company with technological operations than one with man-power operations. This project can be used to convey materials ranging from those in powdery forms grit forms, and stones in the size of crushed granites. If applied to the foundry technology practical (sand mould) under gone by the department. The lecture will experience ease in carrying out his lecture as well as satisfaction since there would not be lack of sand as this can be seen to, by an attendant and the lectures will have all the student of the Department in attendance.  

TABLE OF CONTENT
Title page
Little of transmittal
Release
Signature
Approval
Dedication
Acknowledgement
Table of content
Abstract

CHAPTER ONE
1.1 Introductions
1.2 Description of the screw conveyor

CHAPTER TWO
2.1 Mode of operation
2.2 Material selections

CHAPTER THREE 
3.1 design
3.2 design analysis
3.3 principle of operation
3.4 capacity of the screw conveyor
3.5 sequence of operation/ construction

CHAPTER FOUR
4.1 assembling of the conveyor
4.2 cost analysis

CHAPTER FIVE
5.1 conclusions
5.2 recommendations
5.3 references    
 

  • Department: Mechanical Engineering
  • Project ID: MCE0333
  • Access Fee: ₦5,000
  • Pages: 46 Pages
  • Reference: YES
  • Format: Microsoft Word
  • Views: 439
Get this Project Materials
whatsappWhatsApp Us