PRODUCTION OF DOMESTIC POWDER


  • Department: Chemical Engineering
  • Project ID: CNG0478
  • Access Fee: ₦5,000
  • Pages: 70 Pages
  • Reference: YES
  • Format: Microsoft Word
  • Views: 408
Get this Project Materials
ABSTRACT
This research project is aimed at producing domestic powder and consequently, three different types of powder were produced, namely, simple face powder (pan-cake), medicated/Antiseptic powder (dristing   powder).

During the various production Talcum, Zinc-oxide, Perfume, Menthol, Tragasan 300 DP (Triclosan), Mineral oil and colour (brown) were the materials used in the production of different powders. And equipment and apparatus used for production  of the three different powders  products are electronic weighing balance, mortar and pistle, beaker, filter paper, mixer and spatula.
 The simple face powder production. Talcum and perfume   or Zinc-oxide and perfume were used and was ratio or measured in other to standize the product. Also the Brown powder (pan-cake) Talcum, mineral oil  Zinc-sterate (Zinc-oxide) and colour were the material used in the production. Thus the Medicated/Antiseptic powder (dustin powder) comprises of Talcum, Irzasan 300 Dp, Menthol, and little addition of zinc-oxide.
All the three powder products has different stages of production and it involves the.

TABLE OF CONTENTS
Letter of Transmittal----
Approval page- ----
Dedication   ----
Acknowledgement---
Abstract--
 
Chapter one
Introduction

Chapter Two
Literature Review
Cosmetics
Cosmetic products
Lip stick
Cream
Powder
Classification of powder
Face powder
Simple powder
Brown powder 
General properties of powder
Slip
Talc
Properties of talc
Zinc oxide (ZNO)
Properties of Zinc oxide
Uses of Zinc oxide
Toilet powder Dustin powder
Function of Antiseptic-Dustin powder
Precaution on Antiseptic Dustin powder Application
Aftershave powder 
Baby powder 
Antiseptic powder 
Menthol
Effect on micro-organisms
Perfume
Preparation of starch
Properties of starch
Test for starch
Uses of starch
 
Chapter Three
3.0Material and Experimental Methodology.
3.1  Material for production
3.2Categories of powders produced .
3.3Production procedure for simple powder
3.4Apparatus and Experiment used
3.5Aim of Experiment (Simple powder)
3.6Method of production
3.61Weighing stage
3.62Mixing stage
3.63Screening
3.7Production of brown powder
3.71Aim of Experiment
3.72Weighing stage
3.73Mixing stage
3.74Screening stage
3.75Compressing stage
3.8     Production  of Medicated/Antiseptic powder
3.81Aim of Experiment
3.82Weighing stage
3.83Mixing stage
3.84Screening stage
3.9      Test of products properties
3.91  Test for covering powder/opacifying ability
3.92Test for Adhesiveness
3.93Test for colour match
3.94Test for pleasing odour
 
Chapter four
4.0Experimental results
4.1Experiment I(Simple face powder)
4.2Experiment II(Brown powder)
4.3Experiment  III(Medicated /Antiseptic powder)
4.4Physical test experimental result for physical properties/Qualities of produced powder.

Chapter  Five
Cost Analysis
Chapter  Six
Discussion

Chapter  Seven
Conclusion/Recommendation

Chapter  Eight
References
Appendix

  • Department: Chemical Engineering
  • Project ID: CNG0478
  • Access Fee: ₦5,000
  • Pages: 70 Pages
  • Reference: YES
  • Format: Microsoft Word
  • Views: 408
Get this Project Materials
whatsappWhatsApp Us