The very fundamental reasons behind this project assignment is to expose student to the very important aspect of private and independent research work not only theories but also subsequent translation of the theoretical research work into a particular function system.

The project construction of automatic fence light controller has been done primarily as a photo type design it could be further modified suit the situation where it will be used e.g when used to activate an alarm the led could be  further modified to suit the situation where it will be used e.g when used to activate an alarm the led could be replaced with a relay and feedback resistor removed (for greater sensitivity)          

 

Title page

Approval 

Abstract 

Table of contents 

Acknowledgement

CHAPTER ONE 

1.1Introduction

CHAPTER TWO 

2.1 Description of components used

2.2 Integrated

2.3 Transistor 

2.4  Diode

2.5  Resistor

2.6  Variable resistor (preset)

2.7 Capacitor

2.8 Light dependent  resistor (LDR)

2.9  Relay

2.10  Transformer

CHAPTER THREE   

3.1Circuit drawing of the automatic fence light controller 

3.2Achieve function of the alto fence light controller 

3.3Rectification stage of the circuit 

CHAPTER FOUR 

4.1Principles of operation of the automatic fence light controller 

4.2Project component /materials cost & packaging 

CHAPTER FIVE 

5.1Test measurement and observation

5.2Conclusion and recommendation

5.3References.