CONSTRUCTION OF STEEL CUPBOARD


  • Department: Mechanical Engineering
  • Project ID: MCE0378
  • Access Fee: ₦5,000
  • Pages: 69 Pages
  • Reference: YES
  • Format: Microsoft Word
  • Views: 388
Get this Project Materials
ABSTRACT
A workshop cupboard is a facility designed from mild steel for the storage of various materials, like book material and non-book materials e.g. workshop tools, labouratory wares and reagents, etc; after operations in a chemical labouratory, mechanical workshop, or else where.
The construction of a workshop cupboard requires the consideration of lots of characteristics of the materials, which are used for the construction, such as physical and mechanical; chemical properties, service requirements, its fabrication process as well as cost of production.
For the constructional project, every necessary technical knowledge was employed; ranging from selection of engineering materials, to constructional procedures which includes sketching, drawing to scale, marking out, cutting, sand preparing, bending and folding, welding and painting, all geared towards the achievement of the construction of a steel cupboard.
In the constructional project, mild steel was chosen as the material of construction not because of its corrosion resistance, but for such properties as cost, strength and ease of fabrication.

TABLE OF CONTENT
Title page 
Approval page 
Letter of Transmittal 
Acknowledgement 
Abstract 
Table of Contents 

CHAPTER ONE 
1.0Introduction 

CHAPTER TWO 
2.0Literature Review 
2.1Historical Development of Cupboard 
2.2Types of cupboard 
2.3Comparison of wood and steel for construction of cupboard.
2.4Steel making 
2.5Steel and its classification 

CHAPTER THREE 
3.0Material Selection 
3.1General Properties of Engineering Materials 
3.2Metal and its properties 
3.3Ferrous metal
3.4Non-ferrous metal 
3.5Properties of steel 
3.6Wood and its properties
3.7Glass and its properties 
3.8Material of construction 

CHAPTER FOUR 
4.0Constructional Procedure / Method 
4.1Sketching and drawing 
4.2Marking out 
4.3Cutting 
4.4Bending and folding 
4.5Welding 
4.6Painting / organic coating 

CHAPTER FIVE 
5.0Discussion 
5.1Description of the modern steel cupboard 
5.2The Base 
5.3The Sides 
5.4The Back 
5.5Partition / Rack 
5.6The Rollers 
5.7The Stopper 
5.8The Lock 
5.9The Door 
5.10Precautions on usage 

CHAPTER SIX 
6.0Conclusion 

CHAPTER SEVEN 
7.0Recommendation 
References 
Appendix

  • Department: Mechanical Engineering
  • Project ID: MCE0378
  • Access Fee: ₦5,000
  • Pages: 69 Pages
  • Reference: YES
  • Format: Microsoft Word
  • Views: 388
Get this Project Materials
whatsappWhatsApp Us