THE DESIGN AND FABRICATION OF A CORN SHELLING MACHINE
- Department: Mechanical Engineering
- Project ID: MCE0355
- Access Fee: ₦5,000
- Pages: 51 Pages
- Reference: YES
- Format: Microsoft Word
- Views: 462
Get this Project Materials
ABSTRACT
This Machine is design and fabricate as a prerequisite for the award of a Higher National Diploma.
We sketch different designs which after consideration of many factors like the machine efficiency, the cost of materials e.t.c before we finally embark on this machine.The machine major component are the shaft, the inner barrel, the outer barrel, the conveyor, the tray etc.The machine is build with very strong and well selected materials which enhances the performance of the machine. The machine efficiency is above 80% but less than 100%. The output of the machine is above average so it satisfies the purpose of which it is design.
LIST OF ILLUSTRATION
(1)Introduction.
(2)Literature Review.
(3)Material Selection.
(4)The Shelling Unit.
(5)The construction and Design method.
TABLE OF CONTENT
COVER PAGE
RELEASE PAGE
LETTER OF TRANSMITTAL
SIGNATURE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWLEDGMENT
ABSTRACT
LIST OF ILLUSTRATION
TABLE OF CONTENT
CHAPTER ONE
INTRODUCTION
CHAPTER TWO
LITERATURE REVIEW
2.1Hand Shelling Method
2.2Direct Linkage Method and its Limitation
2.3Refined Design Method and its Specification
CHAPTER THREE
SHELLING UNIT AND DESIGN CALCULATION
3.1The Frame
3.2Spinning Shaft Design
3.3Shaft Analysis
3.4Belt Drive
CHAPTER FOUR
MATERIAL SELECTION
4.1Materials Selection and Design Of Shaft
4.2Selection and Location Of Bearing
4.3Electric Motor Selection
4.4Selection of Pulley Material
CHAPTER FIVE
CONSTRUCTION AND DESIGN METHOD
5.1The Shaft
5.2Metal Tray
5.3Shelling Unit
5.4Outlet
5.5Barrel
5.6The Perforated Metal Sheet
5.7Sequence Of Assembly
5.8Operation Of Corn Shelling Machine
- Department: Mechanical Engineering
- Project ID: MCE0355
- Access Fee: ₦5,000
- Pages: 51 Pages
- Reference: YES
- Format: Microsoft Word
- Views: 462
Get this Project Materials
