DESIGN AND FABRICATION OF A PRINTING I BLOCK MACHINE
- Department: Mechanical Engineering
- Project ID: MCE0328
- Access Fee: ₦5,000
- Pages: 55 Pages
- Reference: YES
- Format: Microsoft Word
- Views: 374
Get this Project Materials
ABSTRACT
Parameters on which clear prints depends were comprehensively investigated. The study revealed that clear print depends on the impressed pressure the working temperature and the gold foil print paper life expectancy.
Also studies were he manner of dependence of these parameters on prints impressed on sheets of varied thickness. The results of these investigation were utizlied in the design and fabrication of an operational manual printing machine using gold foil sheet depositor clear prints were impressed on papers during the new machine’s operation.
TABLE OF CONTENTS
Title page
Letter of transmittal
Release
Approval page
Dedication
Acknowledgement
Abstract
List of figures
List of tables
List of symbols
Table of contents
CHAPTER ONE
1.1introduction
1.2literature review and data collection
1.3experimental determination of pressure for prating
1.4 design specification
CHAPTER TWO
2.1Design solutions
2.2Alternative A press foot printer
2.3Alternative B; crank arm (handle )
2.4Alternative C; automatic (motorized) printer
2.5Comparison of alternative and choice
CHAPTER THREE
3.1Design selection and analysis of parts of chosen alternative
3.2Theory of design/ design calculation
3.3The design of the shaft (Hollow)
CHAPTER FOUR
4.1construction of prototype
4.2general
4.3material selection
4.4sequence of construction and assembly
CHAPTER FIVE
5.1Testing of prototype (test – run)
5.2Evaluation of machine efficiency
5.3Operator’s manual
5.4Costing (cost analysis)
5.5Problems Encounter
5.6Conclusion
5.7Recommendation
Reference
- Department: Mechanical Engineering
- Project ID: MCE0328
- Access Fee: ₦5,000
- Pages: 55 Pages
- Reference: YES
- Format: Microsoft Word
- Views: 374
Get this Project Materials