ABSTRACT

The constructional project involved the construction of an industrial barrow of standard size was constructed.

The process used went across various Engineering practice. These involved the procurement of galvanized steel of 0.00mm to 300mm thickness. Some galvanized steel rods and pipes were also used for the construction. 

The Engineering drawing was done followed by the following operation: Marking out, cutting, bending and folding.

Finally, the construction of an industrial barrow was done successfully and clean, portable and standard industrial barrow was obtained. These industrial barrows can be used in material handling activities.

TABLE OF CONTENTS

Title page 

Dedication 

Acknowledgement 

Letter of posterity / Transmittal 

Abstract 

Content 

CHAPTER ONE 

1.0Introduction 

1.1Origin and History 

1.2Aim 

CHAPTER TWO 

Literature review 

CHAPTER THREE 

3.0Sequence of operation 

3.1Prototype construction 

3.2Operation description 

3.3Material analysis 

3.4Testing of construction and analysis 

3.5Testing and results. 

CHAPTER FOUR 

4.0Cost evaluation 

4.1Cost of standard wheel 

CHAPTER FIVE 

Discussion 

CHAPTER SIX 

Recommendation 

Conclusion 

CHAPTER SEVEN 

Bibliography