TABLE OF CONTENT
Title page i
Certification ii
Dedication iii
Acknowledgement iv
Table of content v
Abstract viii
CHAPTER ONE 1
1.0 Introduction 1
1.1 Statement of problem 3
1.2 Aim and objectives of the study 5
1.3 Scope of the study 5
1.4 Justification of the study 5
CHAPTER TWO 6
2.0 Literature review 6
2.1 Background of the study 6
2.1.1 Type of tricycle 8
2.1.1.2 Recumbent delta Tricycle 10
2.1.1.3 Recumbent Tadpole 11
2.1.1.4 Recumbent hand crank 12
2.1.1.5 Recumbent Tandem 12
2.1.1.6 Special Purposes 13
2.1.17 Tricycle Rickshaw 13
2.1.1.8 Freight tricycle 14
2.2 Important of tricycle 15
2.3 Casting 15
2.4 Sand Casting 19
2.5 Moulding sand used 20
2.5.1 Refractoriness 21
2.5.2 Chemical inertness 22
2.5.3 Permeability 22
2.5.4 Surface finish 22
2.5.5 Cohesiveness 22
2.5.6 Flow ability 23
2.5.7 Collapsibility 23
2.5.8 Availability 23
2.6 Aluminium 23
CHAPTER THREE 28
3.0 Experimental procedure 28
3.1 Pattern making 28
3.2 Casting of the product 28
3.3.1 Crucible Pot 29
3.3.2 Crucible Furnace 29
3.3.3 Drag and Cope 30
3.3.4 Rammer 30
3.3.5 Scrapper 30
3.3.6 Charcoal 30
3.3.7 Shovel 30
3.4 Steps involves in the casting operation 31
3.4.1 Sad preparation for moulding 31
3.4.2 Melting of Aluminium 32
CHAPTER FOUR 34
4.0 Experimental procedure 34
4.1 Lather machine 34
4.2 Universal testing machine 34
4.3 Results 35
4.4 Discussion 35
CHAPTER FIVE 37
5.0 Conclusion and Recommendations 37
5.1 Conclusions 37
5.2 Recommendation 37
Reference
ABSTRACT
A tricycle is a three-wheel vehicle used in conveying goods and humans from one place to another especially is the rural and farm area absorbing energy from the moving systems, drakes are generally applied to a rotating axle or wheels but may also take another form such as a moving fluid. Brake pedals are irregular in shape in at least the direction. Casting of the brake pedal is to reduce the weight, the sand casting is a process by which sand is use to prepare the mould. The pattern is made with a manna wood. Aluminiun was used to east the part. During the casting of the product to increase the strength of the aluminium, silicon was added to it during melting. Specimen were also produced which was latter machined and due for tensile test.