DESIGN AND CONSTRUCTION OF A MICROCONTROLER BASED INTELLIGENT EMERGENCY LIGHT SYSTEM

Department: Electrical Engineering
Project ID: ELE0452
Access Fee: ₦5,000
Pages: 67 Pages
Reference: YES
Format: Microsoft Word
Views: 959

ABSTRACT

This Project presents the design and construction of a microcontroller based Intelligent Emergency Light System. It is based on Hardwired control logic and micro programmed control logic using a real time program known as Assembly language. This Project Intelligent Emergency Light will turn on the Emergency light only during the Dark condition. Ordinary emergency light will be switched ON during the power failure condition. So that if there was a power failure in day time the ordinary emergency light will also be switched on. So there is a loss of power. Our system will continuously monitor the light falling on the LDR sensor and when there was no sufficient light over the LDR & there is a power failure then it will switch on the Light. So that the place at which the circuit was connected will always be in Bright. And if there is a power failure then the power to drive the emergency light was taken from the Battery supplied with the circuit. The Whole system was controlled by the AT89S52 Microcontroller. It continuously monitors the Light in the Room and it will switch ON the emergency light if there is a power failure and the Room was Dark.

TABLE OF CONTENTS

CHAPTER ONE

INTRODUCTION

1.1 OBJECTIVE OF THE PROJECT

1.2 JUSTIFICATION OF THE PROJECT

1.3 THE SCOPE OF THE PROJECT

1.4 PROJECT REPORT ORGANIZATION

CHAPTER TWO

REVIEW OF RELATED LITERATURE

2.0 HISTORY OF EMERGENCY LIGHTS

CHAPTER THREE

DESIGN METHODOLOGY