ABSTRACT
The aim of this project was to construct one office table and four chairs.
In the course of this project the length of plank used was 12†and we used about 4 number (mahogany) of 1†thickness, ¾ plywood of 1 sheet of 1†thickness, as well as ¼†plywood of ½ and glue 1 tin wenner 1 rod, foam ½ sheet. Fabrics 4 years, spraying materials and 21b of nail were utilized to effect the construction of office table and chairs.
The materials were marked out to the required sizes, cut, folded, fited, assembled, nail, mort iced and then spraying it finally to prevent corrosion attack
There are the necessary constructional procedure steps adopted in the project. The accuracy and precision with which the construction steps and consequently, the assemblage of the component parts greatly enhanced our aim of constructing a suitable equipment for use of one table and four chairs.
The aim of constructing the table and the chair is to enable chemical Engineering department as future Engineer to know and also learn how to construct an office table or chairs and the essence of it. The cost of production of the office table and chairs as at 7th August, 2005 is N21,000.00
TABLE OF CONTENTS
TITLE PAGE
APPROVAL PAGE
LETTER OF TRANSMITTAL
DEDICATION
ACKNOWLEDGEMENT
ABSTRACT
TABLE OF CONTENTS
CHAPTER ONE
1.1 Introduction
CHAPTER TWO
2.0 Literature Survey
2.1 Definition and types of table and chairs
2.2 Chemistry and structure of timber and wood
2.3 Chemical components of wood
2.4 Categories of wood
2.5 Categories of wood
2.6 Uses of wood
2.7 Structure of timber
2.8 Wood pattern making
2.9 Pattern makers tools
2.10Materials
2.11Dowel pins
2.12Types of patterns
2.13Core points and core boxes
2.14Timber and wood carving
2.15Toothed cutting tools
2.16Foaming or steel square.
CHAPTER THREE
3.0 Constructional procedure
3.1 Cutting list
3.2 Sketching and Drawing
3.3 Cutting
3.4 Assembling
3.5 Sand papering
3.6 Paderded
CHAPTER FOUR
4.0 Discussion
4.1 Conclusion
4.2 Recommendation
4.3 Appendices
4.4 References
