CONSTRUCTION OF A 12 VOLT BATTERY CHARGER
- Department: Electrical Engineering
- Project ID: ELE0161
- Access Fee: ₦5,000
- Pages: 18 Pages
- Reference: YES
- Format: Microsoft Word
- Views: 1,050
Get this Project Materials
ABSTRACT
The battery which has always serve as a sources of electrical current has in the past been invalid and inmost cases seen as monument after implicating as battery wound have to be brought over and over again the implicating has been that of lot of money is been spent for this purpose we give appraise for the advancement of technology which today had led to the production of battery which could be made functional after it energy may be used up this has been made possible by recharging the battery.
Therefore the recharging production of battery charge which adequately take care of recharging battery has come stay in this project we will produce a batter charger and examine the component it is made up of the process involved and their stages as well
TABLE OF CONTENT
Cover page
Title page
Approval page
Dedication
Acknowledgement
Abstract
Table of content
CHAPTER ONE
1.0Introduction
1.1Component of the battery charge
1.2Transformer
1.3Rectifier
1.4Capacitor
1.5Resistor
1.6Diode
1.7 Light emitting diode
CHAPTER TWO
2.0Construction
2.1Construction procedure
2.2Block diagram (not included)
2.3Schematic diagram (not included)
2.4Ham put diagram (not included)
CHAPTER THREE
3.0Principle of operation
3.1Test and result
3.2Procedure for charge
CHAPTER FOUR
4.0Application
4.1Short coming
4.2Maintenance
CHAPTER FIVE
5.0Bill of quantity
5.1Precaution
5.2Conclusion
CHAPTER SIX
6.0Bibliography
- Department: Electrical Engineering
- Project ID: ELE0161
- Access Fee: ₦5,000
- Pages: 18 Pages
- Reference: YES
- Format: Microsoft Word
- Views: 1,050
Get this Project Materials